Endress+Hauser Nivotester FTR525 - 8 Commissioning; Function Check; Switching on the Measuring Device; Setting the Operating Language

Nivotester FTR525
Endress+Hauser
27
Commissioning
8 Commissioning
8�1 Function check
Make sure that the post-installation and post-connection check has been carried out
before you commission your measuring point:





the description of these Brief Operating Instructions available in the following sections.
8.2 Switchingonthemeasuringdevice
The Nivotester FTR525 is powered up by connecting the supply voltage. The local display

successfully starting up.
1M
2M
Grenzstand 1
-8.8.8.8.8
Max
M i n
Initialisation

FTR525 01.00.00


Initialisation...
Initialisation of the connected FDR57

Grenzstand 1
%
068
▴
▴
▴▴
1M
Standard measured value display (according to the set-
tings or factory settings)
8�3 Setting the operating language
The operating language is set in function 3510; English (factory setting) and German are
available for selection as standard.
Other operating languages as a replacement for German are available on request.