Endress+Hauser Nivotester FTR525 - 9 Operation; Reading off the Device Locking Status; Reading off Measured Values; Analysis

44
Nivotester FTR525
Endress+Hauser
Operation
9 Operation
9.1 Readingothedevicelockingstatus
The locking status of the device can be read as follows:

- The locking symbol lights permanently on the display.
- The note "Key locked" occurs if pressing a key.
• Write protection by changing the user 
- In the function 3121 the current user status is displayed.
- The locking symbol
occurs when selecting a function without access right
.
9.2 Readingomeasuredvalues
The measured values can be read from the display depending on the display mode

In the functions 2510 "Min/Max limit (1M)" and 2520 "Min/Max motion (2M)", the

9�3 Analysis
The following functions can be used to analyse the settings of the measuring system,
consisting of the Soliwave microwave barrier and the Nivotester FTR525.
9�3�1 Signal strength limit (1M)
Application
2000
→
Application analysis
2500
→
Signal strength limit (1M)
2540
This function is used to display the current signal strength of the limit detection (1M)
depending on the performed setup.
Example:
033
1M
2
540
2
1
3
4
5
Max. detection range
Set detection range
033
1M
2540
27 Displaysignalstrengthoflimitdetection(1M)
1 Setlowerlimitofadjustment(LL)infunction2112→28
2 Setdetectionrange(=0-100%ofsignaloutput)
3 Percentagevalueofthecurrentsignalstrength
4 Setupperlimitofadjustment(UL)infunction2113→29
5 Currentsignalstrength