Endress+Hauser Nivotester FTR525 - Adjustments to the Display

Nivotester FTR525
Endress+Hauser
37
Commissioning
8.4.2.16 Switch-opointswitchingoutput2
Application
2000
→
Switchingoutputs
2400
→
Switchingoutput2
2420
→
Switch-opointoutput2
2423
In this function the switching point of switching output 2, below which the switching
2413
8.4.2.17 Switch-ondelayswitchingoutput2
Application
2000
→
Switchingoutputs
2400
→
Switchingoutput2
2420
→
Switch-ondelayoutput2
2424

ON
for switching output 1 (function
2414
8.4.2.18 Switch-odelayswitchingoutput2
Application
2000
→
Switchingoutputs
2400
→
Switchingoutput2
2420
→
Switch-odelayoutput2
2425

OFF
for switching output 1 (function
2415
8�4�3 Adjustments to the display

display mode and the language.
8�4�3�1 Tag
System
3000
→
Management
3100
→
Device management
3110
→
Tag
3111
This function can be used to enter the name for the measuring point (Tag). This name is
displayed in the measured value display depending on the selected display mode.
25).
8�4�3�2 Language
System
3000
→
Display
3500
→
Language
3510
This function is used to select the language for the FTR525.
Options: "English", "German"
Other languages are available on request; these will replace the "German" language option.
8�4�3�3 Display mode
System
3000
→
Display
3500
→
Display mode
3520

the maximum of two measuring channels are displayed.
Options: "% limit (1M)", "Bargraph limit (1M)", "Tag limit (1M)", "% motion (2M)" *,
"Bargraph motion (2M)" *, "Tag motion (2M)" *, "Bargraph alternat. (1M/2M)" *,
"Tag alternating (1M/2M)" *