40
Nivotester FTR525
Endress+Hauser
Commissioning
8�4�3�7 Brightness setting
System
3000
→
Display
3500
→
Brightness
3560
This function is used to set the display brightness.
Options: 1 (low brightness) to 7 (high brightness)
8�5 Congurationmanagement
Following commissioning of the microwave barrier, it is possible to save the current
following function
of each other.
8�5�1 Save user settings
System
3000
→
Management
3100
→
Device management
3110
→
Save user settings
3112
This function can be used to save up to three separate sets of user settings.
Options: "User settings 1" to "User settings 3"
We recommend that users also separately make a note of their device settings (for
example, in order to restore them following a technical failure). The "User-specific
60) can be used for this.
8�5�2 Device reset
System
3000
→
Management
3100
→
Device management
3110
→
Device setting
3113
This function can be used to restore the saved user settings or perform a factory reset.
Options: "Factory reset", "User reset 1" to "User reset 3"
• An overview of all factory settings that will be loaded following a factory reset can be
61).
• Saved user settings are not deleted following a factory reset.
8�6 Simulation
The simulation allows to simulate various measured values in the process as well as the
device alarm behavior, without any real level limit or movement detection, and to check
power supply.
• With active simulation and a return to operation display, the error "Simulation" is shown
47).
To Next Page
Loading...
