Endress+Hauser Prosonic S FMU90 PROFIBUS DP - Submenu Pump Control N → Pump Alarm; Submenu Rake Control; Submenu Relay Configurat. → Relay N (Function: Limit); Submenu Relay Configurat. → Relay N (Function: Time Pulse)

Operating menu Prosonic S FMU90 PROFIBUS DP
104 Endress+Hauser
14.6.12 Submenu "Rake control"
Parameter set R1200 "Rake control"
• Upstream water
• Downstream water
• Function
Parameter set R1201 "Rake control"
• Switch-on point
• Switch-off point
Parameter set R1202 "Rake control"
• Switching delay
• Failure mode
Parameter set R2204 "Relay allocation → Relay N"
• Function
• Invert
14.6.13 Submenu "Relay configurat. → Relay N" (function: limit)
Parameter set R1203 "Relay N"
• Function → Limit → Limit XXX
• Limit type
• Switch-on point
• Switch-off point
• Switch on/min.
• Switch off/min.
• Upper switchpt.
• Low switch point
• Hysteresis
Parameter set R1204 "Relay N"
• Switch delay
• Invert
• Failure mode
14.6.14 Submenu "Relay configurat. → Relay N" (function: time pulse)
Parameter set R2103 "Relay N"
• Function → Time pulse
• Pulse width
• Pulse time
Parameter set R2104 "Relay N"
• Invert
• Failure mode
14.6.15 Submenu "Relay configurat. → Relay N" (function: counting
pulse)
Parameter set R1203 "Relay N"
• Function → Counting pulse → Pulse flow N
• Counter unit
• Pulse value
• Pulse width
Parameter set R1205 "Relay N"
• Pulse counter
• Overflow x 10^7
• Reset counter
• Start counter
• Stop counter