Endress+Hauser Prosonic S FMU90 PROFIBUS DP - Menu Flow N

Prosonic S FMU90 PROFIBUS DP Operating menu
Endress+Hauser 95
Parameter set L1017 "LVL N check value"
Correction
Parameter set L1018 "LVL N correction"
Offset
Parameter set L1020 "LVL N blocking distance"
Blocking distance
Parameter set L1019 "LVL N limitation"
• Limitation
• Upper limit
• Lower limit
Parameter set L1020/L1021 "LVL N ext. input M"
Only for devices with additional digital inputs (FMU90********B***)
• Input M
• Function
• Value
14.1.3 Submenu "Simulation"
Parameter set L1022 "LVL N simulation"
• Simulation
• Sim. level value
• Sim. volume value
14.2 Menu "Flow N"
Navigation to the menu:
• If Operating mode = Level + flow:
Flow → Flow → Flow N
• If Operating mode = Flow:
Flow → Flow → Flow N
• If Operating mode = Flow + backwater:
Flow → Flow 1 + backwater → Flow N
14.2.1 Submenu "Basic setup"
Parameter set F1003 "Flow N sensor sel."
• Input
• Sensor selection
• Detected
Parameter set F1004 "Flow N linearisat."
• Type
• Flow unit
• Curve
• Width
• Edit
• Status table
• alpha
• beta
• gamma
• C
• Max. flow
Parameter set F1010 "Flow N empty cal."
• Empty E
• Blocking distance