Endress+Hauser RIA 250 - Operating matrix overview

4.3 Operating matrix overview
INPUT RANG WIRED WREST CURVE DAMP Sc DP Sc LO Sc HI COMPT FTMP Analogue input
Input range Wiring type *2 Cable
resistance *2
Curve Signal
damping
Sensor decimal point *3
Sensor scale *3 0%
Sensor scale *3 100%
Cold junction temperature *2
Constant comparison temp. *2
DISPL DI DP DI LO DI HI OFFST BG LO BG HI Display Decimal
point *2
Display value 0%
Display value 100%
Offset Scale
bargraph/ analogue output 0%
Scale bargraph/ analogue output 100%
OUTPT RANG FAIL SIMU Analogue output *1
Output range
Fault operation
Current/ voltage simulation
*1 Menu group only available with analogue output option *2 Address available/not available dependent on set up value
in temperature measurement
*3 Menu group only available when linearization table is selected *4 Menu group available/not available dependent on set up value
in linearization table
*5 Address only available after user code entered
LIM1 MODE1 SETP1 HYST1 DELY1 Set point/ Fault monitor
Operation mode
Set point Hysteresis Time delay
LIM2 MODE2 SETP2 HYST2 DELY2 Set point/ Fault monitor
Operation mode
Set point Hysteresis Time delay
PARAM CODE LICOD BRNUM BRLED PNAME SW-ID FREQ TEST A ERR L ERR Operation parameter
User code Set point
code *5
Display brightness
Bargraph brightness
Programme name
Software version
Power frequency
Test Aktual fault Last fault
TABLE COUNT DEL LSHOW Linearization table *3
Number of points
Delete all points
Display all points
NO 01 to NO
32
H1 to H32 Y1 to Y32
Linearization point position *4
Sensor value (X-value)
Display value (Y-value)
SERV SCODE Service parameter
Service code
Process display
52
EN-RIA02.CHP
Thu Jan 11 14:04:35 2001
Farbprofil: Deaktiviert
Komposit Standardbildschirm