Endress+Hauser RIA 250 - Linearization table

5.6 Linearization table
The following addresses are only displayed in the setting up
menu if linearization of the input signal has been selected.
Address
CURVE is set to TABLE.
Parameter Setting up selections
Default
settings
Actual
* Number of points
COUNT
Enter of the number of
linearization points are to
be allocated.
The number of points can
be inceased at a later
time.
Number:
2to32
2
The first and last points are automatically set by the unit and are allocated the values
of sensor scale 0% (
SC LO) to display value 0% (DI LO) and sensor scale 100%
(
SC H1) to display value 100% (DI HI).
* Delete all
points
DEL
All linearization points are
deleted to allow input of a
new linearization curve.
YES All linearization points
are deleted after
acknowledgement
NO All linearization points
remain unchanged
NO
TABLE
Parameter Setting up selections
Default
settings
Actual
Actual fault
AERR
Display address:
Display of actual fault
message
Fault code see
Chapter 7
E 000
Last fault
LERR
Display address:
Display of last fault
message
Fault code see
Chapter 7
E 000
Process display
62
EN-RIA02.CHP
Thu Jan 11 14:04:53 2001
Farbprofil: Deaktiviert
Komposit Standardbildschirm