The following addresses are only displayed when the
linearization points (
LSHOW) are active (YES). Addresses for
linearization points 1 to 32 are identical.
The entry sequence of the linearization points is random.
The sensor values (X-Value) are automatically sorted
upwards before they are saved.
Unused points, sensor value is identical “
-----”, are
automatically deleted and the number of points respectively
lowered in number.
If points are to be added later then the value under
COUNT
must be increased to the required number. The new
addresses will be added before the last value. The remaining
linearization points should be entered in the new addresses.
This again is independent from sequence. The added values
will again be sorted upwards automatically before being saved.
Parameter Setting up selections
Default
settings
Actual
* Display all
points
LSHOW
In order to simplify
operation and setting up
it is advisable to blend
out all linearization points
after they have been set
up.
The contents of the
points remains
unchanged and the
display can be switched
on again at any time.
YES All linearization points
are indicted in the
display
NO The linearization
points are blended
out
YES
Process display
63
EN-RIA02.CHP
Thu Jan 11 14:04:54 2001
Farbprofil: Deaktiviert
Komposit Standardbildschirm
To Next Page
Loading...
