5. Operating parameter description
This chapter describes all the setting parameters of the unit
including the relative ranges and default settings. All
parameters can be simply changed front end without the need
for further equipment. The settings can also be easily
changed using the serial interface and PC operating software.
Once settings in the function groups analogue input and
display/measurement range have been changed please check
for possible effects these might have on the other function
groups.
The addresses identified by * as well as “Possible settings”
are only available dependent on the previously set up
parameter or the options released. The following listing shows
the maximum possibilities.
For documentation purposes the actual settings can be written
down in the parameter list.
(Fold-out at the end of this manual.)
Process display
53
EN-RIA02.CHP
Thu Jan 11 14:04:37 2001
Farbprofil: Deaktiviert
Komposit Standardbildschirm
To Next Page
Loading...
