Operation RIA45
18 Endress+Hauser
Setup menu Description
Application Application selection
1-channel 1-channel application
2-channel 2-channel application
Diff-pressure Difference pressure application
AI1 Lower range* Lower measuring range limit for Analog in 1
AI1 Upper range* Upper measuring range limit for Analog in 1
AI2 Lower range* Lower measuring range limit for Analog in 2
AI2 Upper range* Upper measuring range limit for Analog in 2
CV Factor* Factor for calculated value
CV Unit* Unit for calculated value
CV Bar 0%* Lower limit for bargraph of calculated value
CV Bar 100%* Upper limit for bargraph of calculated value
Linearization* Linearization of calculated value
No lin points Number of linearization points
X-value X-values for linearization points
Y-value Y-values for linearization points
Analog in 1 Analog input 1
Signal type Signal type
Signal range Signal range
Connection Connection type (only for Signal type = RTD)
Lower range Lower limit of measuring range
Upper range Upper limit of measuring range
Tag Designation of analog input
Unit Unit of analog input
Temperature unit Unit for temperature; only visible is "Signal type" = RTD or
TC
Offset Offset of analog input
Ref junction Reference junction (only for Signal type = TC)
Reset min/max Reset min/max value for analog input
Analog in 2 Analog input 2
see Analog in 1
Calc value 1 Calculated value 1
Calculation Type of calculation
Tag Designation of calculated value
Unit Unit of calculated value
Bar 0% Lower limit for bargraph of calculated value
Bar 100% Upper limit for bargrapg of calculated value
Factor Factor for calculated value
Offset Offset for calculated value
No lin points Number of linearization points
X-value X-values for linearization points
Y-value Y-values for linearization points
*) Is only displayed if "Application" = "Diff pressure" is configured.
To Next Page
Loading...
