Endress+Hauser ria45 - Page 19

RIA45 Operation
Endress+Hauser 19
Setup menu Description
Reset min/max Reset min/max values
Calc value 2 Calculated value 2
See Calc value 1

Analog out 1 Analog output 1
Assignment Assignment for analog output
Signal type Signal type of analog output
Lower range Lower range limit of analog output
Upper range Upper range limit of analog output

Analog out 2 Analog output 2
See Analog out 1

Relay 1 Relay 1
Assignment Assignment of value to be monitored with relay
Function Operating function for relay
Set point Set point for relay
Set point 1/2 Set points 1 and 2 for relay (only, if Function = Inband,
Outband)
Time base Time base for gradient evaluation (only, if Function =
Gradient)
Hysteresis Hysteresis for relay

Relay 2 Relay 2
See Relay 1

Back Return to main menu
*) Is only displayed if "Application" = "Diff pressure" is configured.
Diagnostics menu Description
 Current diagn Current diagnostic

Last diagn Last diagnostic

Operating time Operating time of the device

Diagnost logbook Diagnostics logbook

Device information Device information

Back Return to main menu
Expert menu Description
 Direct access Direct access to an operting function

System System settings
Access code Protection of operating menu by means of access code
Overfill protect Overfill protection
Reset Device reset
Save user setup Save settings made in the setup

Input Inputs
The following parameters are available in addition to the parameters from the Setup menu:
Analog in 1 / 2 Analog input 1 / 2
Bar 0% Lower limit for bargraph of analog input