Endress+Hauser ria45 - Expert Simulation Settings

RIA45 Appendix
Endress+Hauser 73
Description Configures the failsafe mode
Options Invalid
Fixed value
Factory setting Invalid
Fixed fail value
Navigation

Expert → Application → Calc value 1/Calc value 2 → Fixed fail value
Description The value configured here is output in the event of an error.
User entry Numerical value
1)
Factory setting 0
Additional information Only visible if "Fixed value" was selected for the "Failure mode".
Allow reset
Navigation

Expert → Application → Calc value 1/Calc value 2 → Allow reset
Description Setting as to whether saved min./ max. values can be reset in the Display
menu without having to enter a user code which may already have been
configured.
Options No
Yes
Factory setting No
Submenu "Diagnostics"
Navigation

Expert → Diagnostics
Verify HW set
Navigation

Expert → Diagnostics → Verify HW set
Description Device hardware check.
Options Yes
No
Factory setting No
Submenu "Simulation"
Navigation

Expert → Simulation
Simulation AO1/AO2
Navigation

Expert → Simulation → Simulation AO1/Simulation AO1