4.5 Operating menu overview
IN1 IN2 RANG CURV DAMP SCDP SCLO SCHI DIDP DILO DIHI DIOF
Analogue
inputs 1/2
Input
range
Curve Signal
damping
Sensor
decimal
point *4
S0%
*4
Sensor
scale
100%
*4
Measured
value
decimal
point
Measured
value
scale 0%
Measured
value
scale
100%
Measured
value
offset
MATH MAOP MCURV FADP1 FA 1 FADP2 FA 2 MADP MAOFF MSCLO MSCHI MDIDP MDILO MDIHI MDIOF
Mathemat.
Channel
*3
Operator Curve Decimal
point
factor 1
Factor 1 Decimal
point
factor 2
Factor 2 Total
decimal
point
offset Scale
X-value
0%
Scale
X-value
100%
Decimal
point
Y-value
Scale
Y-value
0%
Scale
Y-value
100%
total offset
DISPL DISOW
Display/
Meas.
range *3
Reference
value
OUT1 OUT2 OREF RANG OLO OH1 FAIL SIMU
Analogue
outputs
1/2 *1
Reference
value *3
Output
range
Output
scale 0%
Output
scale
100%
Fault
operation
Simulation
Voltage/
current
LIM1 LIM2 LREF MODE SETP RESP HYST DELY TRDT
Alarm set
points 1/2
*2
Reference
value *3
Operating
mode
Switch
point *7
Reset
point
*7
Hysteresis
*7
Time
delay
*7
Time
trend
monitoring
*7
TAB1 TAB2 COUN DEL LSHO
Linearisat.
table *4
Number
of points
Delete all
points
Display
all points
NO101 -
NO120
NO201 -
NO220
NOM01 -
NOM20
X101 -
X120
X201 -
X220
XM01 -
XM20
Y101 -
Y120
Y201 -
Y220
YM01 -
YM20
Linearisat.
points *5
x-axis y-axis
PARAM ALT CODE LICOD PNAME SW-ID TEST A ERR L ERR
Operation
parameters
alternate
pump
controll
Operator
code
Set point
code *6
Program
name
Software
version
Test Actual
fault
Last fault
SERV SCODE FRSET
Service Service
code
Reset
parameters
*1 Menu group only available with analogue output option
*2 Menu group only available with alarm relay option
*3 Address/menu group only available with analogue input 2
option
*4 Address/menu group only available when linearisation
table is selected
*5 Menu group available/not available dependent on set up
value in linearisation table
*6 Address only available after user code entered
*7 Address available/not available dependent on the values
set up under set point monitor
Process transmitter
49
To Next Page
Loading...
