Parameter Setting up selections
Default
settings
Actual
setting
User code
CODE
User presettable operation
code.
An already set code can only be
changed if the old code is first
entered and the unit setting up
released. Then a new code can
be set up.
Value:
0000 to 9999
There is no operation
code active if “0" is set
0
* Set point code
LICOD
Set point changes require or
do not require a user defined
release code
YES Set points are user code
protected
NO Set points can be
changed without setting a
user defined code
YES
This address is only active when a user defined operation code is set up.
Programme name
PNAME
Display address:
Display of the software used
in the unit
Software version
SU-ID
Display address:
Display of the version
number of the software used.
Test
TEST
Test function for diverse
hardware components;
These are activated after the
component is selected.
OFF None
REL1 Relay 1 is energised
REL2 Relay 2 is energised
DISP All segments on the
numeric display and all
LEDs are activated for
approx. 5s.:
OFF
Energised relay means
rest position (yellow LED
on), in fault alarm and set
point infringement the
relay is de-energised.
Once this address has been left the unit automatically switches the address to
OFF .
The red LED flashes during active test function!
Process transmitter
61
To Next Page
Loading...
