EndRun Sonoma D12 - Page 88

S o n o m a U s e r M a n u a l
72
C H A P T E R N I N E
73
S o n o m a U s e r M a n u a l
C O N T R O L A N D S T A T U S C O M M A N D S
syskernel Prints the currently booted linux kernel, either 0 or 1, where 0
is the factory-installed kernel and 1 is the upgraded kernel.
sysosctype Prints the installed system oscillator type, which is one of
TCXO, OCXO or Rubidium.
sysrootfs Prints the currently loaded linux root le system image, either
0 or 1, where 0 is the factory installed root le system, and 1 is
the upgraded root le system.
sysstat Prints detailed NTP status information. Included is the offset of
the NTP-steered system clock to the CDMA Subsystem clock,
the NTP daemon leap indicator bit values, the TFOM, the time
of the most recent update and the current leap seconds value.
systemio
(optional)
Returns the current settings for any installed, system options.
See Chapter 10 - Options, CPU Module Options for more
information.
systemiocong
(optional)
An interactive utility that allows you to modify the settings for
the system options. See Chapter 10 - Options, CPU Module
Options for more information.
systimemode Prints the time mode settings in effect for the front-panel dis-
play, or any optional Time Code or Serial Time output.
See the systimemodeconfig command.
systimemodecong Interactive utility that guides you in conguring the time mode
settings for the front-panel display, or any optional Time Code
or Serial Time output. Allows setting to the LOCAL, GPS or
UTC timescale. See the systimemode command.
sysversion Prints the Linux Subsystem root le system version informa-
tion.
unlockkp Command to unlock access to the front-panel keypad EDIT
key. See the lockoutkp and kplockstat commands.
updatekernelag Command to update the ag stored in FLASH that is read by
the Linux bootloader at boot time to select operation with either
the factory-installed or upgraded kernel.
updaterootag Command to update the ag stored in FLASH that is read by
the Linux bootloader at boot time to select operation with either
the factory-installed or upgraded root le system.
upgradekernel Command that performs the Linux Kernel upgrade process.
upgradercvr Command that performs the CDMA Receiver upgrade process.
upgraderootfs Command that performs the Linux Root File System upgrade
process.
upgradesubsys Command that performs the CDMA Subsystem rmware
update process.
wrt_sw_opt Command to enable a software option. See Chapter 10 - Op-
tions, Software Options for information.