EnGenius EAP1250 - Page 21

21
Attaching the EAP1750H/EAP1300 to a ceiling
using the provided T-Rail connectors:
1. Attach the T-Rail connectors to the bottom cover of the
EAP using the provided short screws.
Note: Two sizes of T-Rail connectors are included in the
mounting hardware kit: 15/16in (2.38cm) and 9/16in
(1.43cm).Ifextraspaceisrequiredtoaccommodatedrop
ceilingtiles,usetheprovidedspacersandlongscrews.
2. Line up the connected T-Rail connectors with an
appropriately sized rail and press the unit onto the rail
until it snaps into place.
Note: ToprotectyourEAP,usetheKensingtonSecurity
Slottoattachacablelock(cablelockisnotincluded).
P2.6*10 Screw
Clip
T-Rail
Clip
Clips
Spacer
P2.6*25 Screw