ENGINEERING
Page 10
Omniguard™ 4
A diagnostic test will automatically run and the unit will print the
date, time and the current alarm setpoints. The unit will then
immediately begin to monitor containment pressure.
Until the containment pressure has reached the operating window,
the status bar will indicate WAITING FOR PRESSURE and the
STATUS LED will flash green.
Note: Logging and printing of monitored pressure
readings does not begin until the containment
pressure has reached the operating window!
You will need to customize the factory Alarm 1 and Alarm 2
setpoints for your application!
Once the containment pressure reaches the operating window (the
area between the Alarm 1 and Alarm 2 setpoints) the unit’s status bar
changes from WAITING FOR PRESSURE to NORMAL and the
STATUS LED changes to a steady green. NORMAL OP is then
printed along with a time-stamp. The STATUS LED changes to
orange to warn of an impending Alarm condition when the pressure
is within 0.005”WC of the Alarm setpoints.
Contractor Name
The
Omniguard 4
can store the name of the Contractor that is using
the unit. The Contractor name will appear in all Job logs and printed
Reports. Only one name can be stored.
To set the Contractor Name --
1. Press MENU to view the Main Menu.
2. Highlight CONTRACTOR NAME using ▲/▼.
3. Press SELECT to view or change the setting.
4. Use the ▲/▼ keys to change the character. Upper and lowercase
letters and numbers are all usable characters to enter.
5. Use the
/
keys to move to the next/previous character to set.
6. When the entire name has been entered, press SAVE to save the
new name and return to the Main Menu.
Pressing the
EXIT
key will return you to the Main Menu without
saving the updated Contractor Name.
Date & Time
The date and time settings are used as a reference time-stamp for
all logged events.
To change the Date & Time --
1. Press MENU to view the Main Menu.
2. Highlight DATE & TIME using ▲/▼ and press SELECT to change
the setting.
To Next Page
Loading...
