ENGINEERING
Page 22
Omniguard™ 4
Using Help
To access Help information on a highlighted topic --
- Press HELP. Detailed information about the unit’s current status
or the highlighted function will be displayed.
To access the Help Menu --
1. Press HELP twice.
2. Highlight the desired topic using ▲/▼.
3. Press SELECT to view the information available for that topic.
Communication
The
Omniguard 4
has built-in USB and Serial ports to connect to a
PC or to an optional External Modem. The Windows® compatible
Omniguard 4 Communication software must be installed in the PC
and is available as a free download @ www.engsolinc.com.
The
Omniguard 4
can communicate with a PC three different ways...
1. Connect a USB cable directly to the PC.
2. Connect a Serial cable directly to the PC.
3. Connect via dialup to the PC. Requires an external modem (with
a phone line connected to it). Configure the modem using the
MODEM SETUP menu item.
Once connected, you can transfer the current Job Log or all Job
Logs to the PC. You can also “remotely monitor” the
Omniguard 4
,
observing pressure, status and log updates as they occur on the job
site.
Before a PC can communicate with an Omniguard
4, you must first download and install the
Omniguard 4 Communication software from our
web site @ www.engsolinc.com. Detailed
instructions for installation and operation of the
software are included with the download.
Transferring a Job Log to the PC
The Job Logs stored in the
Omniguard 4
’s memory can be transferred
to an IBM compatible PC for permanent storage, statistical analysis
and summary report generation. Job Logs transferred to a PC can
be reviewed and reprinted any number of times.
To transfer a job log --
1. Install the Communication program into your computer.
2. Select either the USB cable (included with your
Omniguard 4
) or
the optional Serial cable (available from your distributor). Plug
the cable into the appropriate connector on the
Omniguard.
To Next Page
Loading...
