SOLUTIONS
Page 19
Owner’s Manual
2. Highlight RESPONSE RATE using ▲/▼ and press SELECT to
view or change the setting.
3. Use ▲/▼ to change the setting.
4. Press SAVE to save the updated setting and return to the Main
Menu.
Pressing the
EXIT
key will return you to the Main Menu without
saving the updated settings.
Display Contrast & Backlight
The contrast level and backlight setting on the LCD screen allows the
user to adjust the display for optimal viewing in varied lighting
conditions. The backlight automatically dims after 4 minutes to
extend battery and backlight life. It can be reactivated by pressing
any key.
Contrast: (default is 50%)
• range is 0% (min) to 100% (max)
Backlight: (default is ON)
• choices are ON or OFF
To change the Contrast or Backlight --
1. Press MENU to view the Main Menu.
2. Highlight DISPLAY from the Main Menu using ▲/▼ and press
SELECT to change the settings.
3. Press
/
to choose CONTRAST or BACKLIGHT and use
▲/▼ to change the settings for each.
4. Press SAVE to save the updated settings and return to the Main
Menu.
Pressing the
EXIT
key will return you to the Main Menu without
saving the updated settings.
Pressure Units
The pressure units used by the
Omniguard 4
to display and record
pressure readings are selectable.
Pressure Units: (default is Inches WC)
• choices are Inches WC (“WC), Millimeters WC (mmWC)
or Pascals (Pa)
To select the desired pressure units --
1. Press MENU to view the Main Menu.
2. Highlight PRESSURE UNITS by using ▲/▼ and press SELECT
to change the setting.
3. Use ▲/▼ to change the pressure units to the desired
measurement.
To Next Page
Loading...
