ENGINEERING
Page 20
Omniguard™ 4
4. Press SAVE to save the updated settings and return to the Main
Menu.
Pressing the
EXIT
key will return you to the Main Menu without
saving the updated settings.
Passcode Protect
The passcode protect feature allows the site manager to assign a
passcode that prevents unauthorized changes to the unit’s settings.
Once enabled, the four digit code must be entered to change any
setting. Settings may be viewed without the passcode.
Passcode Protect: (default is OFF)
Passcode: (default passcode is 0 0 0 0)
• passcode can be set to ON or OFF
• master passcode is 7 7 7 7
To set and enable the Passcode --
1. Press MENU to view the Main Menu.
2. Highlight PASSCODE PROTECTION from the Main Menu using
▲/▼ and press SELECT to view or change the setting.
3. Press ▲/▼ to select the passcode On or Off.
5. Press
/
to move to the Passcode digits.
4. Set each digit of the passcode using ▲/▼.
5. Press
/
to move from one digit to the next.
6. Press SAVE to save the updated setting and return to the Main
Menu.
Pressing the
EXIT
key will return you to the Main Menu without
saving the updated settings.
Note: In the event that the passcode is lost or
forgotten it can be reset and settings can be
changed using the master passcode.
Aux Alarm Setup
The AUX ALARM output can be used to activate either of two
optional accessories; the Remote Auxillary Alarm or the Telephone
Autodialer. The Aux Alarm Setup menu item is used to set which
device type is attached to the AUX ALARM connector.
AUX MODE: (default is Remote Alarm)
• choices are Remote Alarm, Autodial 1 min, Autodial 5 min
or Autodial 10 min
To select the Autodialer device --
1. Press MENU to view the Main Menu.
2. Highlight AUX ALARM SETUP using ▲/▼ and press SELECT to
view or change the settings.
To Next Page
Loading...
