ENGINEERING
Page 4
Omniguard™ 4
Section 1: Basic Care
The
Omniguard 4
is built and engineered to provide you with
dependable performance for years to come. Following these basic
guidelines will insure that you get maximum use from your unit.
Once the unit is set up, field operation is easy. Complete reports are
virtually automatic, providing the most accurate records of your job
site conditions available.
• This unit is designed to measure differential pressure only from
+0.250” to -0.250” WC (optional pressure ranges are available).
Caution: Never apply pressure to the inlet port by
mouth or with any other strong pressure device.
High pressure will permanently damage the
sensor.
• Use only
Omniguard
thermal printer paper.
• Always store the unit away from sources of excessive heat, dust
and moisture.
• Never attempt to repair any of the internal components of the
unit.
• Protect the unit from strong shocks or vibrations. Be sure the lid
is securely closed whenever transporting the unit.
• Be sure to plug your
Omniguard 4
into a power supply that
complies with the National Electrical Code. Keep all connections
dry. As with any electrical device, this unit has the potential to
cause an electrical shock hazard.
• If your unit must be shipped at any time to another location or for
service, use the original packing material and shipping box for
optimum protection during shipping.
To Next Page
Loading...
