Configure the Grid Profile
If you did not set the Grid Profile during registration or if you need to change the Grid Profile, use the
Envoy interface to configure the Grid Profile (alternate voltage and frequency trip points) for the system.
Refer to the Envoy Communications Gateway Installation and Operation Manual at
http://www.enphase.com/support for instructions.
Build the Virtual Array
When the system is energised and the Envoy detects all the installed microinverters, you can create the
virtual array in Enlighten from the installation map you created. Once the virtual array is built, Enlighten
displays a graphic representation of the PV system. It also shows detailed current and historical
performance information. Go to http://www.enphase.com for more information on the Enphase Enlighten
web-based monitoring and analysis.
To scan and upload the map and build the array:
1. Scan the installation map and upload it to the Activation form online.
2. Use Array Builder to create the virtual array in Enlighten. Use your installation map as your
reference.
NOTE: Go to
http://enphase.com/support/videos/
to view the Array Builder demo.
3. If you do not already have an account, go to http://www.enphase.com and click “Enlighten Login”
to register.
To Next Page
Loading...
