46
1. Press SET button while HOUR COUN PARA is displayed.
2. Select the parameter with UP/DOWN buttons.
3. Press the SET button.
Afterwards, the limit value is selected. When the parameter exceeds this limit value, hour counter will
start.
1. Press SET button while HOUR COUN LEVL is displayed.
2. Enter a limit value by using UP/DOWN buttons. You can select different digits with SET or BACK
buttons.
3. Exit from the menu when selection is complete.
4. When exiting from the menu with the BACK or ESC button, don’t forget to save the changes.
Alarm Settings
Different parameters can be assigned to the 4 alarms that the device has.
Following operations are described for a single alarm but they are the same for the other 3 alarms.
Activating Alarm
Alarm is activated by following these steps:
1. Press the SET button while Setup Alarm is displayed.
2. While Alarm Enable is displayed, Press the SET button and select ENABLE or DISABLE with
UP/DOWN buttons.
3. Press the SET button after completing your selection.
To Next Page
Loading...
