Enviro Q1LI - Operating Instructions; Turn off the Appliance; Room Thermostat (Transmitter Operation); Smart Thermostat (Transmitter Operation)

Turn off the Appliance
Press the ON/OFF Key on the Transmitter. The Transmitter LCD display
will only show the room temperature and Icon (see Figure 10). A single
“beep” from the IFC conrms reception of the command and both the
pilot light (if the unit is not set to continuous pilot) and main burner will
turn off.
Room Thermostat (Transmitter Operation)
The Remote Control can operate as a room thermostat. The thermostat
can be set to a desired temperature to control the comfort level in a
room. To activate this function, press the Thermostat Key (see Figure
5). The LCD display on the Transmitter will change to show that the
room thermostat is “ON” and the set temperature is now displayed (see
Figure 10). To adjust the set temperature, press the Up or Down Arrow
Keys until the desired set temperature is displayed on the LCD screen
of the Transmitter.
Smart Thermostat (Transmitter Operation)
The Smart Thermostat function adjusts the ame height in accordance to the difference between the set
point temperature and the actual room temperatures. As the room temperature gets closer to the set point
the Smart Function will modulate the ame down. To activate this function, press the Thermostat Key (Figure
5) until the word “SMART” appears to the right of the temperature bulb graphic (Figure 11). To adjust the
set temperature, press the Up or Down Arrow Keys until the desired set temperature is displayed on the LCD
screen of the Transmitter.
Room Temperature
Set Temperature
Thermostat ON
Figure 10: Remote Control Displays
Set Temperature.
Remote Flame Control
The Proame 2 GTMF has six (6) ame levels. With the
system on, and the ame level at the maximum in the
appliance, pressing the Down Arrow Key once will reduce
the ame height by one step until the ame is turned
off. The Up Arrow Key will increase the ame height
each time it is pressed. If the Up Arrow Key is pressed
while the system is on but the ame is off, the ame will
come on in the high position (refer to Figure 12). A single
“beep” will conrm reception of the command.
Figure 11: Remote Control’s Smart Flame Function.
Figure 12: Remote Control’s Flame Levels.
Flame Off
Flame Level 1
Flame Level 5
Maximum Flame Level
Operating Instructions
12