15
Maintenance And Service
cLeaning DecoRative suRfaces:
Painted and porcelain faces should be wiped with a damp cloth periodically. If a plated face has been
purchased, it should be unpacked/unwrapped carefully to avoid getting anything on the surface of the
nish, including cleaners, polish and nger prints. It is important to note that ngerprints and other
marks can leave a permanent stain on plated nishes. To avoid this, give the face a quick wipe with
denatured alcohol on a soft cloth BEFORE lighting the replace. Never clean the face when it is
hot. Do not use other cleaners as they may leave a residue, which can become permanently etched into
the surface.
gLass DooR RemovaL:
In order to install the log set, and
for regular cleaning, the glass door
must be removed. There are two
(2) door latch mechanisms on top
the glass door as shown in Figure
17. Each latch has a hole at the front
to use the door tool, supplied with
the unit, to pull the mechanisms
straight out and up. When the top
latches are unhooked, lean the
door forward and then lift it up out
of the alignment slots at the bottom
corners of the rebox, shown in
Figure 18.
To replace the glass door, simply
reverse the above procedure.
Warning: Do not touch or attempt
to remove the glass door if the
replace is not completely cold.
WARNING: Never operate the
replace with the glass door
removed.
Figure 17. Top latches for glass door
Figure 18. Bottom Alignment Slots for glass door.
Door Latch Mechanism
Door Tool Hole
Alignment Slot
(both corners)
*Parts removed
for clarity*
To Next Page
Loading...
Need help?
General
