3.5.2 Handling of a Branched Tree
1. Saw the branches apart.
2. Open the grapple.
3. Take the butt end of one of the branches into the grapple.
4. Saw a disk at the butt end and feed normally.
5. Take the butt end of the other branch into the grapple.
6. Saw a disk at the butt end and feed normally.
3.5.3 Handling of a Tree Lying on the Ground
1. Open the grapple.
2. If trunk counter is in use, carry out felling sawing (lift the tilt up
and carry out sawing) to increase the trunk number.
3. Take the butt end of the tree into the grapple.
4. Saw a disk at the butt end.
5. Feed normally.
To Next Page
Loading...
Need help?
General