Instructions for use Epec 4W30 44
(C) Epec Oy Seinäjoki Finland
10.3 Switches
− Press the switches and check, whether data is displayed.
− 11 = switch in the bottom, 00 = switch open.
− The output numbering in the Switch display corresponds to the
following switches.
21 = Programming wheel (always 11) 33 = Knives open
22 = Programming wheel (always 11) 34 = Tracks open
25 = Cancel key 35 = Back knife
26 = Enter key 36 = Urea
27 = Saw 37 = Turn left
28 = Turn left 38 = Turn right
29 = Turn right 39 = Grapple closed
30 = Tilt up / down 40 = Grapple open
31 = Tilt up 9 = Feed backward
32 = Tilt down 13 = Feed forward
10.4 Cabin Outputs
− The states of the cab outputs are indicated in the same way as the
grapple outputs:
10 = output on, no error.
11 = output on, error.
01 = output at zero, error.
00 = output at zero, no error.
− The numbering is as follows:
10 = Proportional pump 14 = Pump 2
12 = Pump 1 16 = Urea
10.5 Preselection Keys
− Press the keys and check, whether data is displayed.
− 11 = switch in the bottom, 00 = switch open.
− The numbering of the outputs in the display of preselection keys
corresponds to the following switches:
1 = Preselection 1 9 = Preselection 9
2 = Preselection 2 10 = Preselection 10
3 = Preselection 3 11 = Preselection 11
4 = Preselection 4 12 = Preselection 12
5 = Preselection 5
6 = Preselection 6 The rest are not in use
7 = Preselection 7
8 = Preselection 8
To Next Page
Loading...