Instructions for use Epec 4W30 37
(C) Epec Oy Seinäjoki Finland
7.40 Tilt Up During Feed Backward (K49)
− This setting is used to activate the
tilt up
function during feed
backward. Thus, by lifting the grapple a little, the feed backward is
made easier.
− If function is in use, it is activated simultaneously with the function
fast feed backward (i.e. when valve "Feed backward 2" is controlled
to open).
− 0 = function not in use, 1 = function in use.
7.41 Additional Pressure During Sawing (K50)
− The setting can be used to clamp the grapple more firmly during
sawing. This way, the tree stays in the grapple tightly.
− When function is in use, the additional pressure activates always
when sawing is carried out.
− 0 = function not in use, 1 = function in use.
To Next Page
Loading...