7.27 Pump Release Delay (K35)
− The setting is used to set the time that the pump is on after the other
outputs have been switched off.
− Setting range 0 – 3 s.
7.28 Proportional Pump in Use (K36)
− This is used to inform the equipment, whether a proportional pump is
in use.
− If no proportional pump is in use, the settings of the pump angle have
no influence and the parameters K5 - K8 are not visible.
− 0 = not in use, 1 = in use.
7.29 Length of Search Pulse (K37)
− Setting of the length of the search pulse.
− Is automatically regulated to get the tree to move 2 cm with one
pulse.
− Because of the automatic regulation this value should not be adjusted
manually when the machine is searching with search pulses. The
suitable pre-set value is 10.
7.30 Low Speed Feeding Pulse (K38)
− Setting of the low speed feeding pulse. No influence, if a proportional
pump is in use.
− Is automatically regulated to get the tree to move 2 cm with one
pulse.
− Because of the automatic regulation this value should not be adjusted
when the machine is searching with low speed. The suitable pre-set
value is 10.
7.31 Slip Prevention (K39)
− This time is used to regulate how long the feed outputs are kept on, if
there comes no length pulses.
− Zero indicates that slip prevention is not in use.
− Setting range 0 – 0.5 s. If the value is too small, the feed will not
work, since the machine thinks too early that the tracks slip.
To Next Page
Loading...
Need help?
General