Epiroc FlexiROC T20 R - Before Starting; Safety; Checks

25
Operator's instructions
3. Daily checks
Before starting
Safety

Danger of moving parts
 Can cause serious injuries
 Set all levers and switches
in NEUTRAL position
before start-up
preparations
 Carry out the procedures
with the engine switched
off

Dangerous compressed
air
 Can cause serious injury
 Release the pressure in
the tank before removing
the filler plug
Checks
Table: Checks before starting.
Check point Inspection Instructions
Drill rig. Visual check Make sure there are no signs of leaks, damage,
breakage or cracks.
Hydraulic oil Oil level Check oil level. Top up as necessary.
Lubrication oil Oil level Check oil level. Top up as necessary.
Motor oil Oil level Check oil level. Top up as necessary.
Compressor oil Oil level Check oil level. Top up as necessary.
Water separator Fuel prefilter Drain off the water
For further instructions, see: Maintenance instructions