53
Operator's instructions
4. Controls
Error messages
Error messages are shown below.
Start-up screen
If the radio box is working then the following screen should be shown on the radio box during start-
up. The figure 0 (A) gives an indication that there is no error message and the box should work
normally. If 0 has changed to another figure then Epiroc's service organization must be informed for
troubleshooting.
Lever fault
The message is shown during engagement if the levers are not in start position.
o
Release the levers for the message to disappear.
The message is shown in the event of a lever fault. Communication is disconnected.
o
Restart the box in test mode and check the levers.
To Next Page
Loading...
