4.5.1 Aspirating liquid
1. Press down the control button to the second stop.
2. Immerse the pipette tip vertically in the liquid.
3. Maintain the immersion depth and let the control button slide back slowly.
Liquid is aspirated into the pipette tip.
4. Wait approx. 3 seconds.
5. Remove the pipette tip from the liquid.
4.5.2 Dispensing liquid
1. Place the pipette tip on the tube inner wall at a steep angle.
2. Slowly press down the control button to the first stop.
The liquid is dispensed.
3. Wait until the flow of liquid stops.
4. Hold down the control button and wipe the pipette tip on the tube inner wall.
Residual liquid remains in the pipette tip.
During dispensing, the additional volume (blow out) does not belong to the dispensing
volume.
4.5.3 Ejecting the pipette tip
1. Press down the control button to the second stop.
The residual liquid is dispensed.
The residual liquid can be discarded.
2. Press the control button down all the way.
The pipette tip is ejected.
4.6 Storing the pipette
The pipette can be stored in a pipette carousel, a wall mount or in horizontal position.
If necessary, wipe the pipette tip against the tube inner wall.
To Next Page
Loading...