Eppendorf Reference 2 - Deactivating the spring load - single-channel pipettes ≤ 1000 µL; Deactivating the spring load - multi-channel pipettes; Adjusting the pipette

25
Maintenance
Eppendorf Reference
®
2
English (EN)
6.8.1 Deactivating the spring load – single-channel pipettes ≤ 1000 μL
Prerequisites
• The ejector sleeve has been removed.
• The lower part has been detached.
6.8.2 Deactivating the spring load – multi-channel pipettes
 Turn the switch spring load to Off.
6.9 Adjusting the pipette
6.10 Cleaning
1. Lightly squeeze the clamps on the lower
part and push the black locking ring onto
the lower part from the top .
2. Insert the lower part and attach the
ejector sleeve.
The execution of changes to the user adjustment and factory adjustment is
described on our website www.eppendorf.com/manuals
.
NOTICE! Damage to device from unsuitable cleaning fluids or sharp or pointed
objects.
Unsuitable cleaning agents can damage the device.
 Never use corrosive cleaning agents, strong solvents or abrasive polishes.
 Check the compatibility with the materials used.
 Please note the information on chemical resistance.
 Do not clean the device with acetone or organic solvents with a similar effect.
 Do not clean the device with sharp objects.
NOTICE! Damage to the device due to penetration of liquids.
 Do not set the pipette aside when the pipette tip is filled.
 Do not allow any liquids to penetrate the inside of the housing.