31
5.3.2 Recalibration
If the error code displays as the gure 5-7, users should calibrate the throttle strictly
as below steps.
Before calibration, please attach the kill switch in the package to the proper posi-
tion. It is forbidden to use other magnets to replace the kill switch for calibration.
Figure 5-7
Recalibration process LCD Displaying
Step1: Long press “
” button for 10s until “CAL FO”
displays.
Step2: Push the throttle to the maximum forward power
position, then press " " button. “CAL ST” will display
and “CAL” will be blinking.
Step3: Pull the throttle to the middle (zero) position whe-
re you can hear a click sound, then press " "button,
“CAL bA” will display and “CAL” will be blinking.
To Next Page
Loading...
