ePropulsion NAVY Evo - 13.3 Propeller Maintenance; 13.4 Replacing the Anode

50
13.3 Propeller Maintenance
Disconnect the battery with outboard before maintenance.
Gloves are recommended to protect your hand from sharp propeller edges.
Check the propeller according to the following instructions, then refer to then refer to
section 2.2 Selecting and Mounting the Propeller to replace a new propeller if neces-
sary.
1. Check the propeller blades for wear, cavitation erosion and other damage.
2. Check the pin for wear and damage.
3. Check for water plants, fishing net or line twine around the propeller.
4. Replace a new anode if necessary.
13.4 Replacing the Anode
Please refer to the gure below to replace a new anode if necessary.
Figure 13-1
Figure 13-2
Plain Washer
Anode
Spring Washer
Screw
Anode