ePropulsion NAVY Evo - 5.1 Display Panel Overview

23
5 Evo Remote Control/Evo Tiller
The Evo Remote Control and Evo Tiller is used for starting and stopping the outboard
motor, adjusting the speed of the motor, conguring the battery parameters, display-
ing the system information and messages, etc. The Evo Remote Control is powered
by either solar power or the built-in lithium battery, but the Evo Tiller is powered by
connecting to the outboard with a communication cable. Evo Remote Control wire-
lessly or wiredly communicates with the outboard control system built in the main
outboard motor, and Evo Tiller can only wiredly communicate with the outboard. The
Evo Tiller itself owns the steering capability, while using the Evo Remote Control, it
requires an additional steering wheel to help steer.
5.1 Display Panel
Figure 5-1
Battery Level Indicator
Fan Fault
Throttle Reset Indicator
Low Power Indicator of
Remote Control
Battery Level / Voltage
Kill Switch Status Indicator
Safety Wristband Status
Indicator
Number of Safety Wristband
Overheat Alert
Hydrogeneration Indicator
Current Speed
Distance / Time
Throttle Power
GPS Status Indicator
Travelled Distance / Time or
Remaining Distance / Time
Wireless Connecting Indicator