33
5.5 Use of Safety Wristband
5.5.1 Pairing Safety Wristband with Evo Control System
Press the “
” and “ ” buttons and hold for a while to display the safety wristband
icon and “SE”. At this time, approach the safety wristband that needs to be paired,
turn on the safety wristband, and the Evo control system displays the “SUC”, indicat-
ing successfully pairing. Keep in this interface and continue to press “ ” to pair the
safety wristband continuously (the maximum number of pairs is 8). After completing
the pairing, press the “ ” button to return to the main page.
Figure 5-9
5.5.2 Man Overboard Protection
After the safety wristband and the Evo control system are paired, when the safety
wristband falls into the water and the Evo control system is on, the outboard will stop
immediately. The Evo control system display will flash with a buzzing sound. The
safety wristband icon ashes and the number of safety wristbands decreases. At this
time, you can continue to operate the machine by returning the throttle to zero posi-
tion. The buzzer of the Evo control system will stop, but the display continues to ash.
If you conrm that you need to cancel the alarm state, please restart the Evo control
system or the disconnected wristband.
5.5.3 Emergency Stop
After the safety wristband and the Evo control system are paired, when the Evo con-
trol system is in operation, short press the button of the safety wristband, the out-
board will stop immediately. The display of the Evo control system will ash with a
buzzer. At the same time, the safety wristband icon ashes and the number of safety
wristbands displayed at the bottom decreases. At this time, you can continue to oper-
ate the machine by returning the throttle to zero position. The buzzer of the Evo con-
trol system stops, but the display continues to ash. If you conrm that you need to
cancel the alarm state, please restart the Evo control system or short press the safety
wristband after 5 seconds.
To Next Page
Loading...
