42
7 Checklist before Use
1. Ensure the propeller is correctly and firmly mounted on the outboard.
2. Ensure the outboard is correctly and firmly mounted on the boat.
3. Ensure the throttle and steering wheel are installed in proper position before
turning on the power.
4. Ensure the throttle travels smoothly with no obstacles.
5. Before connecting the battery, check and make sure there is no poor contacts or
defects in cables.
6. Check and ensure the main switch is able to power on and off normally. After that,
turn off the main switch.
7. Ensure the battery has enough power.
8. Ensure the Evo Remote Control has enough power when the Remote Control is
wirelessly connecting to the outboard.
Start the outboard only when the propeller is beneath water, as the rotating pro-
peller is dangerous.
If the cable is immersed in water, please dry it completely before connecting it to
the battery or power on the system.
8 Starting the Outboard
1. Complete the check list.
2. Remove the kill switch from the Remote Control/Tiller.
3. Push/Turn the throttle to zero position.
4. Connect the battery to the outboard.
5. Fix the outboard with a proper trim angle.
6. Turn on the main switch. If the outboard is connected to an E Series Battery,
please also press the battery power button to power on.
7. Press “ ” button to turn on the Remote Control/Tiller and the main page will
display.
8. Carry out preference setting and battery configuration if necessary.
9. Tie the kill switch to your wrist or life vest, then attach the kill switch on the
Remote Control/Tiller.
10. Push/Turn the throttle slowly to start your outboard.
To Next Page
Loading...
