43
9 Stopping the Outboard
Usually, it’s recommended to stop the outboard as the following procedures.
1. Return the throttle to zero position.
2. Wait until the outboard stops, then detach the kill switch from the Remote
Control/Tiller Handle.
3. Press and hold the “ ”button until the Remote Control/Tiller Handle is powered
off.
4. Turn off the main switch. If the outboard is connected to an E Series Battery,
please also press the battery power button to power off.
5. Tilt the outboard above water surface or detach it from boat.
If the outboard motor will not be used soon, it’s recommended to tilt the out-
board out of water, otherwise erosion may occur. In addition, it is recommended
to apply protective coating.
The outboard will stop if one of the situations occurs.
1. The throttle is in zero position.
2. The kill switch is not in the correct position of Remote Control/Tiller Handle.
3. The main switch is off.
4. The communication between Remote Control/Tiller Handle and outboard
breaks.
5. The connection between battery and outboard breaks.
6. Failure exists in the control system (e.g. motor is blocked or the low battery
voltage level is detected).
To Next Page
Loading...
