47
12 Thread the communication cable into the
bellow
In order to protect the cable and the beauty of the machine, it is recommended that
when using a 5m communication cable, follow the following operations to thread the
communication cable into the bellow:
Step 1: Remove the handle shaft, the decorative cover and the upper case, remove the
card holder, and thread the cable through the bellow (it is recommended to insert the
hard line into the bellow rst to help thread the communication cable).
Figure 12-1
Step 2: Put the cable into the card wire slot, and then put it into the cable hole of the
lower case.
Figure 12-2
To Next Page
Loading...
