EPSON Stylus COLOR 680/777/777i Revision B
Disassembly and Assembly Disassembly 67
4.2.2 Operation Panel removal
The panel board equipped with printer is as follows:
- Stylus COLOR 680: C383PNL
1. Remove the Housing from the printer. (Refer to Section 4.2.1.)
2. Remove 2 screws (C.B.S 3x6 F/Zn) securing the Operation Panel Assembly. Then,
disconnect the Operation Panel Assembly from the Printer Mechanism.
Figure 4-4. Removing 2 screws for Operation Panel
C A U T I O N
When removing the Upper Housing from the left and right Panel,
don’t broke these parts since they were fastened slightly with glue.
(Refer to following pictures.)
n
Tightening Torque for screw
• C.B.S-TITE R3x6 F/Uc screw for housing front side: 6 +/- 1kgf.cm
• C.B.S 3x6 F/Zn screw for housing back side : 6+/- 1kgf.cm
n
It is not necessary to glue the Upper Housing to the Left and
Right Panel.
C A U T I O N
n
Ensure that C.B.S-TITE 3 x 6 F/Uc screws are used for the two
screws on the front side of the printer. The tips of these screws
are rounded for user’s safty.
Fasten Portion
C.B.S 3x6 F/Zn
To Next Page
Loading...
