EPSON Stylus COLOR 680/777/777i Revision B
Disassembly and Assembly Disassembly 71
4.2.4 CR motor removal
1. Remove the Housing from the printer. (Refer to Section 4.2.1.)
2. Using tweezers or a small screwdriver, slide the CR Lock Lever to front and
release the CR Lock Lever from the CR unit. Then move the CR unit to the center
area of the CR shaft.
3. Loosen the CR Timing Belt by pushing the Driven Pulley Holder to right using a
screwdriver, and remove the Timing Belt carefully from the pinion gear on the CR
motor. Refer to Figure 4-xx.
Figure 4-10. Removing the Timing Belt
Step 2
CR Timing belt
To Next Page
Loading...
