Epson 680Pro - LQ B/W Dot-matrix Printer - Waste Drain Ink Pad Unit Removal

EPSON Stylus COLOR 680/777/777i Revision B
Disassembly and Assembly Disassembly 73
4.2.5 Waste drain ink pad unit removal
1. Remove the Housing from the printer. (Refer to Section 4.2.1.)
2. Remove one screw (C.B.P-TITE 3x8 F/Zn) on the front right side of the printer.
(viewed from front side)
Figure 4-12. Removing one screw securing the Waste ink pad unit
3. Remove two screws (C.B.P- TITE 3x8 F/Zn) and take some cables off from the
cable hook in the Waste drain ink pad unit as shown in the following figure.
Figure 4-13. Removing one screws & cables at the back side of the printer
4. Remove the Waste drain ink pad unit from the printer
C.B.P-TITE 3x8 F/Zn screw
C.B.P-TITE 3x8 F/Zn
C.B.P-TITE 3x8 F/Zn