Epson 680Pro - LQ B/W Dot-matrix Printer - CR Unit Removal

EPSON Stylus COLOR 680/777/777i Revision B
Disassembly and Assembly Disassembly 91
4.2.12 CR unit removal
1. Remove the Housing from the printer. (Refer to Section 4.2.1.)
2. Remove the CR timing belt from the CR pinion gear. (Refer to Section 4.2.4.)
3. Release the Printhead FFC from the cable holders on the LD roller shaft holder.
And disconnect the Printhead FFC from the connectors CN8 and CN9 on the Main
board.
Figure 4-43. Taking Printhead FFC off