EPSON Stylus COLOR 680/777/777i Revision B
Disassembly and Assembly Disassembly 84
C H E C K
P O I N T
Tor
n
Make sure that the Torsion spring 0.22 is hung to the following
suitable position.
Figure 4-31. Torsion spring 0.22 for PE detection lever
Figure 4-32. Torsion spring 0.22 for HP detection lever
Torsion spring 0.22
PE sensor lever
Torsion spring 0.22
HP/IC sensor lever
C H E C K
P O I N T
n
Make sure that the HP/PE sensor cable is placed to the suitable
groove on the LD roller shaft holder.
Figure 4-33. Sensor cable placing position (1)
Figure 4-34. Sensor cable placing position (2)
n
Make sure that the each sensor lever turn back smoothly by
moving it after the sensor was assembled to the LD roller shaft
holder.
HP/PE sensor
HP/PE sensor cable
HP/PE sensor cable
To Next Page
Loading...
