EPSON Stylus COLOR 680/777/777i Revision B
Disassembly and Assembly Disassembly 88
5. Open the spur gear 25.6 hook with a pair of tweezers and then slide the paper eject
roller to the right while pulling it toward to remove it.
Spur gear 25.6
Paper eject roller
A D J U S T M E N T
R E Q U I R E D
n
When you replace the Frame front, make sure to lubricate the
specific amount of G26 to the Frame front. Refer to the Chapter
6Figure6-5.
n
When you replace the Paper eject roller with new one, make sure
to lubricate the specific amount of G26 to the Spur gear 25.6.
Refer to the Chapter 6 Figure.
n
Assemble the Paper eject roller in the following procedure.
1. Set the Spur Gear 25.6 to the cut out hole in the Main frame.
2. Align the shape with the spur gear 25.6 hole, insert the paper
eject roller shaft, and then press the spur gear 25.6 hook until it
is closed.
3. Slide the paper eject roller and then insert it in the shaft guide
holder.
n
When you assemble the Front frame to the Printer mechanism,
set the CR unit to the left side and assemble the Front frame
from the right side. Be careful not damage the CR lock lever.
n
Fasten the Front frame with C.B.S Screw 3x6 F/Zn in the order
of 1,2.
n
Tightening torque for screw
• C.B.S 3x6 F/Zn screw for Front frame : 9+/-1 kgf.cm
1
2
To Next Page
Loading...
