EPSON Stylus COLOR 680/777/777i Revision B
Disassembly and Assembly Disassembly 99
7. Remove the Pad holder (Paper return plate) from the ASF frame.
Figure 4-59. Removing the Pad holder (Paper return plate)
.
C H E C K
P O I N T
n
Make sure that the each tip of the Torsion spring 25.7 is set in the
slot of the Pad holder and ASF frame. Refer to Figure 4-57.
n
Make sure that the Pad holder moves smoothly after assembling
it to the ASF frame.
Pad holder
ASF Frame
n
When you replace the ASF frame or Hopper with the new one,
make sure to lubricate the specific amount of G26 into the groove
on ASF frame. Refer to Figure 6-2 Figure 6-3 & Figure6-4 in the
Chapter 6.
n
Fasten the ASF unit C.B.S-TITE (P4) 3x8 F/Zn screw (left screw
in the following figure), C.B.S-TITE3x6 F/Zn screw (right screw
in the following figure) in the order of following figure.
Figure 4-60. ASF fixing screws fastening order
n
Tightening torque for screw
• C.B.S-TITE (P4) 3x6 F/Zn screw for ASF : 9+/-1 kgf.cm
(right screw in above figure)
• C.B.S-TITE(P4) 3x8 F/Zn screw for ASF : 9+/-1kgf.cm
(left screw in above figure)
1
2
1
To Next Page
Loading...
