Epson AcuLaser C1900 - Chapter 6 Maintenance; Maintenance; Consumables and Regular Replacement Parts; Cleaning

EPSON AcuLaser C1900/AcuLaser C900 Revision B
Maintenance Maintenance 218
6.1 Maintenance
This chapter explains the maintenance of AcuLaser C1900 / AcuLaser C900. The
maintenance of AcuLaser C1900 / AcuLaser C900 is designed for users to do
maintenance.
No lubrication or adhesion is required for AcuLaser C1900 / AcuLaser C900.
6.1.1 Consumables and Regular Replacement Parts
AcuLaser C900 requires the replacement of the Consumables (by user) and Regular
Replacement Parts (by serviceman) as listed in Table 6-1 below:
Note *1: The time for replacement is displayed by “EPSON Printer Window !3”.
*2: With AcuLaser C900, the warning of life of the Fuser Unit or Secondary Transfer
Roller does not appear. For maintenance, therefore, replace the Fuser Unit and
Secondary Transfer Roller immediately when a malfunction or print quality trouble
related to these components has occurred. Replace the Fuser Unit and Secondary
Transfer Roller at the same time.
6.1.2 Cleaning
Wipe off the dirt on the exterior surface of the printer with a dry and soft clean cloth. If
the dirt is not easy to remove, use a neutral detergent. Vacuum the dust and paper strips
inside the printer.
The table below specifies the cleaning method for the part. Use of any cleaning method
other than specified can affect the printer function.
Table 6-1. Consumables and Regular Replacement Parts
Name Time for Replacement Replacement by
Developer Cartridge 4.5k Pages
*1
User
1.5k Pages
*1
User
Photoconductor Unit 45k Pages
*1
User
Intermediate Transfer Unit 210k Pages
*1
User
Waste Toner Collector 25k Pages
*1
User
Fuser Unit
*2
120k Pages Serviceman
Secondary Transfer Roller
*2
120k Pages Serviceman
C A U T I O N
Upon replacement of the Fuser Unit and Secondary Transfer
Roller, be sure to reset the counter.
(Refer to “Initializing the counter” (p.214))
Table 6-2. Cleaning
Cleaning Part Period Cleaning Method
Paper load roller When paper feed performance deteriorates Wipe it with a dry cloth
C A U T I O N
Do not use thinner or benzine since it may deteriorate the plastic
parts and rubber parts.