Epson AcuLaser C1900 - Page 76

EPSON AcuLaser C1900/AcuLaser C900 Revision B
Product Description Control Panel 76
Note : Values in parentheses in Clear Condition column are cleared as a result. If a value
exceeds the range, then there is no guarantee of the value managed by the controller to
exceed that.
Table 1-49. Information and Methods of Management List
Information
Name
Count
Processing
and Storage
Location
Range Units
Counting
Conditions
Clear Conditions
Total Pages Controller ~99,999,999 Pages When printing (EEPROM initialization)
Total Planes Controller ~99,999,999 Planes When transcribing (EEPROM initialization)
Color Pages Controller ~99,999,999 Pages When printing (EEPROM initialization)
Thick Planes Controller ~99,999,999 Planes When printing (EEPROM initialization)
Thick Color
Pages
Controller ~99,999,999 Pages When printing (EEPROM initialization)
Jam Count Controller ~100,000 Counts When a jam occurs (EEPROM initialization)
C Toner Engine 0 ~ 100 % When printing Detecting a new C Toner
0 ~ 16,777,215 Images C toner TOD Detecting a new C Toner
M Toner Engine 0 ~ 100 % When printing Detecting a new M Toner
0 ~ 16,777,215 Images M toner TOD Detecting a new M Toner
Y Toner Engine 0 ~ 100 % When printing Detecting a new Y Toner
0 ~ 16,777,215 Images Y toner TOD Detecting a new Y Toner
K Toner Engine 0 ~ 100 % When printing Detecting a new K Toner
0 ~ 16,777,215 Planes K toner TOD Detecting a new K Toner
C Toner
Changes
Controller 0 ~ 10,000 Counts When replacing C
toner
(EEPROM initialization)
M Toner
Changes
Controller 0 ~ 10,000 Counts When replacing C
toner
(EEPROM initialization)
Y Toner
Changes
Controller 0 ~ 10,000 Counts When replacing C
toner
(EEPROM initialization)
K Toner
Changes
Controller 0 ~ 10,000 Counts When replacing C
toner
(EEPROM initialization)
Photoconductor Engine 0 ~ 100 % When printing Detecting a new
Photoconductor
Photoconductor
Change
Controller 0 ~ 10,000 Counts When replacing
Photoconductor
(EEPROM initialization)
Fuser Engine 0 ~ 100 % When printing SelecType
Transfer Unit Engine 0 ~ 100 % When printing Detecting a new Transfer
Unit
Transfer Unit
Change
Controller 0 ~ 10,000 Counts When replacing
Transfer Unit
(EEPROM initialization)
Fuser Temp Controller -20 ~ 20 - - (EEPROM initialization)
Developer Duty Engine 1 ~ 5 - - None
2nd BTR Offset Engine -15 ~ 15 - - None
Color Controller 0 ~ 255 - - (EEPROM initialization)
MCU Controller - - - -
Error Code 1 Controller - - When an error occurs SelecType,
(EEPROM initialization)
Error Page 1 Controller - - When an error occurs
:::::
Error Code 20 Controller - - When an error occurs
Error Page 20 Controller - - When an error occurs
Table 1-49. Information and Methods of Management List (continued)
Information
Name
Count
Processing
and Storage
Location
Range Units
Counting
Conditions
Clear Conditions